LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate crankshaft stub, vibration damper hub inside diameter and sealing surface of timing gear cover seal with clean engine oil. DO NOT apply grease to seal. Position seal onto Crankshaft Seal Installer/Cover Aligner (T88T-6701-A).
  2. Position timing gear cover seal installer and seal onto the crankshaft end. Force seal into recess by tightening bolt. See Fig 1. Remove timing gear cover seal installer. Apply a 1/4" (6 mm) bead of silicone sealer to keyway inside vibration damper hub.
  3. Using Vibration Damper Installer (T52L-6306-AEE), install vibration damper. To complete installation, reverse removal procedure. See TORQUE SPECIFICATIONS .
Fig 1: Installing Timing Cover Oil Seal
G94H65059Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals