LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (1.9L 4-CYL - VIN [J]) >> Removal & Installation >> Engine >> Installation

Removal & Installation: Engine: Installation

WARNING: This page is about a different car, the 1992 Mercury Tracer, 1992 Ford Escort, 1991 Mercury Tracer, and 1991 Ford Escort. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Tighten upper transaxle-to-engine bolts before tightening the lower bolts. Tighten all bolts to specification. See TORQUE SPECIFICATIONS  table at end of article.
  2. When installing fuel lines, install new "O" rings on fuel lines. Use only specified fuel resistant "O" rings (Brown in color). Lightly coat "O" rings with clean engine oil before installing. Clean fittings and replace garter spring (if necessary).
  3. Adjust all control cables and fluid levels. Fill cooling system with Ford Coolant (E2FZ-19549-AA). Evacuate and recharge A/C system.
NOTE: On M/T models, remove engine and transaxle as an assembly.


  1. To install, reverse removal procedure. Tighten all bolts to specification. See TORQUE SPECIFICATIONS  table at end of article.
  2. Use NEW axle shaft nut. Lubricate axle shaft splines with Lubricant (C1AZ-19590-D) before installing in transaxle.
  3. When installing fuel lines, install new "O" rings on fuel lines. Use only specified fuel resistant "O" rings (Brown in color). Lightly coat "O" rings with clean engine oil before installing. Clean fittings and replace garter spring (if necessary).
  4. Adjust all control cables and fluid levels. Fill cooling system with Ford Coolant (E2FZ-19549-AA). Evacuate and recharge A/C system.
scientia non olet · About LEMON Manuals