LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (1.9L 4-CYL - VIN [J]) >> Removal & Installation >> Crankshaft Front Seal >> Installation

Crankshaft Front Seal: Installation

WARNING: This page is about a different car, the 1992 Mercury Tracer, 1992 Ford Escort, 1991 Mercury Tracer, and 1991 Ford Escort. However, it is still accessible from the selected car via links, so may be relevant.

Using Seal Installer (T81P-6700-A), install seal in oil pump housing. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS  table at end of article.

scientia non olet · About LEMON Manuals