LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 4.6L V8 - VIN [W] >> Removal & Installation >> Engine >> Installation

Removal & Installation: Engine: Installation

  1. To install, reverse removal procedure. Tighten all bolts to specification. See TORQUE SPECIFICATIONS  table at end of article.
  2. When installing fuel lines, install new "O" rings on fuel lines. Use only specified fuel resistant "O" rings (Brown in color). Lightly coat "O" rings with clean engine oil before installing. Clean fittings and replace garter spring (if necessary).
  3. Adjust all control cables and fluid levels. Fill cooling system with Ford Coolant (E2FZ-19549-AA). Evacuate and recharge A/C system.
scientia non olet · About LEMON Manuals