Removal & Installation: Camshaft: Installation

1. Coat components with engine oil and install. Install all bolts and tighten finger tight in both camshaft caps. Tighten bolts to 72-106 INCH lbs. (8-12 N.m) in sequence. See Fig 1. Loosen all bolts 2 turns. Tighten bolts to 72-106 INCH lbs. (8-12 N.m) in sequence.
2. Ensure camshaft end play is within specification. See CAMSHAFT  table under ENGINE SPECIFICATIONS at end of article. To install remaining components, reverse removal procedure. Tighten all bolts to specification. See TORQUE SPECIFICATIONS  table at end of article.

CAUTION: Ensure proper procedure is used when installing timing chains to prevent engine damage. See TIMING CHAINS .

Fig 1: Camshaft Cap Bolt Removal & Installation Sequence

Courtesy of FORD MOTOR CO.