LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Crown Victoria Base, AOD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 4.6L V8 - VIN [W] >> Overhaul >> Cylinder Block

Cylinder Block

  1. Maximum warpage information is not available from manufacturer. Check cylinder bore diameter, out-of-round and taper. Cylinder bore is measured at 1/2" below top of cylinder block head surface, and 1/2" above piston when at bottom of cylinder bore.
  2. Bore cylinder block if measurements are not within specification. See CYLINDER BLOCK  table under ENGINE SPECIFICATIONS at end of article.
CAUTION: Before boring cylinder block, install main bearing caps and tighten bolts to specification. This prevents main bearing bores from being distorted when boring cylinder block.
scientia non olet · About LEMON Manuals