Odometer Reading Incorrect, Increases Or Decreases Greatly
- Enter self-test mode (hold in "TRIP RESET" button and turn ignition switch from "OFF" to "RUN" position). Observe zeros on digital display and then release "TRIP RESET" button.
- Test one, as indicated by "01" in the ones and tenths digit of odometer, should pass by displaying a "P" on the speedometer ones digit and sounding a constant pass tone. If okay, go to next step. If not, replace speedometer module.
- Advance from test one to odometer memory test by pressing "TRIP RESET" button until "07" is displayed in odometer. Test passes if "P" is displayed in speedometer ones digit and a pass tone is heard. If okay, go to next step. If not, replace speedometer module.
- Check speedometer for correct operation. If okay, perform SPEEDOMETER CONSTANTLY READS TOO HIGH OR TOO LOW and SPEED INDICATOR JUMPS UP AND DOWN ERRATICALLY tests.