LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2019 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> (Entertainment TELEMATIC Module (ETM) - Electrical Diagnostics - 500 - Except Electric) >> DTC Troubleshooting >> B140C-1A-Rear Right Audio Speaker Output-Circuit Resistance Below Threshold-Premium >> Diagnostic Test

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    1. Turn the ignition on and open one of the Rear doors.
      NOTE:

      A front door must remain open whenever checking or erasing Entertainment Telematic Module (ETM/LTM) DTCs.

    2. With the scan tool, record and erase the ETM DTCs.
    3. Cycle the ignition switch from on to off, wait five seconds and then back to on.
    4. Turn the Radio on and set the volume to 25.
    5. Adjust the speakers to the Rear and center.
    6. With the scan tool, read ETM DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

      • The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  2. CHECK THE AMPLIFIER 
    1. Make sure one of the front doors is still open.
    2. With the scan tool, erase the DTCs.
    3. Turn the ignition off.
    4. Disconnect the Amplifier C1 harness connector.
    5. Turn the ignition on.
    6. Turn the radio on and set the volume to 25.
    7. With the scan tool, read ETM DTCs.

      Is the DTC active?

      Yes 

      • Go To  3

      No 

  3. CHECK THE (X52) RIGHT REAR AUDIO (+) CIRCUIT, AND THE (X58) RIGHT REAR AUDIO (-) CIRCUITS FOR A SHORT TOGETHER 
    1. Disconnect the ETM C1 harness connector.
    2. Check for continuity between the (X52) Right Rear Audio (+) circuit, and the (X58) Right Rear Audio (-) circuit at the Radio C1 harness connector.

      Is there continuity between the (X52) Right Rear Audio (+) circuit, and the (X58) Right Rear Audio (-) circuit?

      Yes 

      • Repair the (X52) Right Rear Audio (+) circuit, and the (X58) Right Rear Audio (-) circuit for a short together.
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

      No 

      • Replace the Entertainment Telematic Module (ETM/LTM) in accordance to the service information. Refer to RADIO, REMOVAL .
      • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .