Switch, Clutch Starter Interlock: Installation
WARNING: This page is about a different variant/trim than selected.
- Engage the locating tab (1) to the pedal assembly and install the switch.NOTE:
If the either retaining feature on the switch will not securely hold the lever in place replace the switch.
- Snap the rivet (2) in place by pushing down, lock the switch in place by rotating the lever (1) until it snaps in place.
- Swing the external lever into place making sure that the stud on the pedal is captured.
- Lock the lever in place by pushing the lock (1) upward.
- With the switch fully locked in place, cycle the clutch pedal several times to verify proper installation.
- Install the pedal assembly into the vehicle Refer to PEDAL AND PAD, CLUTCH, INSTALLATION .
.