Bearing, Clutch Release: Installation

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Verify that the release bearing is snapped into the release fork and not sitting on top of it.

Lubricate the crankshaft pilot bearing and the input shaft splines with Mopar® high temperature bearing grease or equivalent.
Install the new release bearing (1) and secure to the release fork.

Courtesy of CHRYSLER GROUP, LLC
Ensure that the release fork fingers (1) and the retention tabs (2) on the release bearing are correctly oriented.
Install the transmission. Refer to INSTALLATION .