Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN INTERMITTENT CONDITION

Turn the ignition on and open one of the front doors.
NOTE:
A front door must remain open whenever checking or erasing DTCs.
With the scan tool, record and erase the DTCs.
Cycle the ignition switch from on to off, wait five seconds and then back to on.
Turn the Radio on and set the volume to 25.
Adjust the speakers to the front and center.
With the scan tool, read the active DTCs.
Does the scan tool display active: B2001-92 FRONT LEFT AUDIO SPEAKER OUTPUT- PERFORMANCE OR INCORRECT OPERATION?

Yes
- Replace the Radio in accordance with the Service Information. Refer to RADIO, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST.