Section 33 (Audio/Video/Entertainment/Connectivity (Service Information) 500 - Electric): Radio: Removal

WARNING: This page is about a different variant/trim than selected.

WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

Disconnect and isolate the 12-volt negative battery cable.
Power down the high-voltage system. Refer to HIGH-VOLTAGE POWER DOWN PROCEDURE .
Remove the center instrument panel bezel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the four radio bezel to instrument panel screws, and remove the radio bezel (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the four radio to instrument panel screws (2).
While removing the radio (1), disconnect the electrical connectors.