Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. Using a scan tool, read the DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Test complete. The conditions that caused this code to set are not present at this time. Verify seat harness is routed correctly to the BCM. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (P133) DRIVER HEATED SEAT RELAY CONTROL CIRCUIT FOR A SHORT TO BATTERY
1. Turn the ignition off.
2. Disconnect the Driver Heated Seat Relay.
3. Disconnect the BCM C3 harness connector.
4. Turn the ignition on.
5. Measure the voltage on the (P133) Driver Heated Seat Relay Control circuit.
  Is there any voltage present?
  
  Yes
  - Repair the (P133) Driver Heated Seat Relay Control circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK FOR BCM MALFUNCTION
1. Connect the BCM C3 harness connector.
2. Using a 12-volt test light, connected to 12-volts, test the (P133) Driver Heated Seat Relay Control circuit.
3. With the scan tool, actuate the Driver Heated Seat Relay.
  Does the test light illuminate with the relay on and extinguish with the relay off?
  
  Yes
  - Replace the Driver Heated Seat Relay according to the service information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Body Control Module (BCM) according to the service information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .