Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK IF DTC IS ACTIVE
1. Ignition on, engine not running.
2. With the scan tool, read HVAC DTCs.
  Is this DTC active?
  
  Yes
  - Go To 2
  No
  - Go To 3
CHECK THE IN-CAR TEMPERATURE SENSOR ASPIRATOR MOTOR
1. Turn the ignition off.
2. Replace the In-Car Temperature Sensor Aspirator Motor in accordance with the Service Information. Refer to CONTROL, A/C AND HEATER, REMOVAL .
3. Ignition on, engine not running.
4. With the scan tool, erase HVAC DTCs.
5. Cycle the ignition off, then back on and check HVAC DTCs.
  Does this DTC reset?
  
  Yes
  - Replace and program the A/C Heater Control in accordance with the Service Information. Refer to CONTROL, A/C AND HEATER, REMOVAL .
  - Perform the HVAC VERIFICATION TEST. Refer to HVAC VERIFICATION TEST .
  No
  - Test Complete
  - Perform the HVAC VERIFICATION TEST. Refer to HVAC VERIFICATION TEST .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. With the scan tool, check the Environmental Data to help identify the conditions in which the DTC was set.
3. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Wiggle the wiring and connectors while checking for shorted and open circuits.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the HVAC VERIFICATION TEST. Refer to HVAC VERIFICATION TEST .
  No
  - Test complete.