HVAC Verification Test

WARNING: This page is about a different variant/trim than selected.

Perform the following procedures to verify that the repair(s) are valid.

Turn the ignition off to the lock position.
Make sure that all accessories are turned off.
Make sure that the battery is fully charged.
Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
With the scan tool, record and erase all Diagnostic Trouble Codes (DTCs) from ALL modules.
Turn the ignition off, remove the scan tool from the DLC (Data Link Connector). Open the door and close the door. Wait a minimum 30 seconds, then turn the ignition on. Reconnect the scan tool.
NOTE:
Disconnecting the scan tool and opening and closing the door will allow the controller to enter into sleep mode.
With the scan tool, perform the HVAC Actuator Calibration Test if an actuator or controller has been replaced or if software has been updated.
Start and run the engine for two minutes while operating all functions of the system that caused the original concern.
With the scan tool, check for DTCs in all modules.
NOTE:
If no HVAC DTCs are present and other modules are reporting DTCs, refer to DTC INDEX .

Is the original condition still present or are there any other HVAC DTCs present?

Yes

Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.