Bezel, Instrument Panel, Center: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
- On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to 12-VOLT POWER DOWN .
- Disconnect the negative 12-volt battery cable.
- Remove the A/C and heater control panel. Refer to CONTROL, A/C AND HEATER, REMOVAL .
- Remove the two screws (1 and 3) that secure center trim bezel (2) to the instrument panel cover.
- Open the glove box door, remove the center trim bezel retaining screw located on the upper right edge of the glove box cavity.
- Using Trim Stick (special tool #C-4755, Trim Stick) or equivalent, disengage the retaining clips from the center trim bezel (1).
- Disconnect the harness from the switch pod and remove the center trim bezel from the vehicle.