Seat Back, Front: Assembly

WARNING: This page is about a different variant/trim than selected.

NOTE:

Passenger seat shown in the illustration, driver seat similar.

Courtesy of CHRYSLER GROUP, LLC

If necessary, install the air bag onto the seat back cushion. Refer to AIR BAG, SEAT, INSTALLATION .
If necessary, install a new heated seat pad onto the seat back cushion. Refer to PAD, HEATER, INSTALLATION .
Position the seat back cover (1) onto the seat back cushion (3) and attach new hog rings (2).
Install the seat back cover and cushion onto the seat back frame.
NOTE:
Vehicles not equipped with the round style head restraint continue to step 8.

Courtesy of CHRYSLER GROUP, LLC
Position the seat back cover and cushion (1) onto the seat back frame.
Install the headrest sleeves (2).

Courtesy of CHRYSLER GROUP, LLC
Install the head restraint (1) onto the seat back. Press the release tab on the two head restraint sleeves (2 and 3) and push the head restraint straight downward.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
High-back seat shown in the illustration, standard seat typical.
Guide the air bag harness (2) in through the opening in the seat cover (1).
Connect the air bag wiring and attach to the seat back frame.
Position the seat cover and cushion (1) fully down onto the seat back frame.

Courtesy of CHRYSLER GROUP, LLC
Fasten the lower J-channel on bottom of seat cover.
Secure the zippers (1) on both sides of the seat back cover.
Connect the hook and loop fasteners (2) at the lower corners.

Courtesy of CHRYSLER GROUP, LLC
On models so equipped, with the armrest (1) placed in the full up position, firmly squeeze seat material inward far enough to expose the circlip (2) mounting slot.
Insert cir-clip into the slot.
Install the seat back frame, cushion and cover. Refer to SEAT BACK, FRONT, INSTALLATION .