LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Body - Interior & Exterior - 500 - Electric) >> Exterior >> Fender, Front >> Removal

Fender, Front: Removal

WARNING: This page is about a different variant/trim than selected.
GC0153235Courtesy of CHRYSLER GROUP, LLC
  1. Open and support the hood.
  2. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
  3. Remove the headlamp assembly. Refer to UNIT, HEADLAMP, REMOVAL .
  4. Open the door and remove the fastener (1) that secures the upper rear of the front fender to the side cowl panel.
  5. Remove the two fasteners (3) that secure the bottom of the front fender to the lower dogleg.
  6. Remove the two fasteners (3) that secure the bottom of the front fender to the lower cowl/bodyside located in the rear area of the wheelhouse.
  7. Remove the upper fender fasteners (5).
  8. Remove the front fastener (4) securing the fender to the front end module.
  9. Remove fender (2) from vehicle and take to bench.
scientia non olet · About LEMON Manuals