LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 500 Lounge, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Body - Interior & Exterior - 500 - Electric) >> Door - Front >> Door >> Removal

Door - Front: Door: Removal

WARNING: This page is about a different variant/trim than selected.
GC0153100Courtesy of CHRYSLER GROUP, LLC
WARNING:

On vehicles equipped with the high voltage system, disconnecting the 12-volt battery negative cable alone will not power down the 12-volt system. You must perform the 12-volt Power Down procedure before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

  1. On vehicles equipped with the high voltage system, power down the 12 volt system. Refer to 12-VOLT POWER DOWN .
  2. Disconnect the negative 12-volt battery cable.
  3. Remove the cowl/scuff panel. Refer to PANEL, COWL TRIM, SIDE, REMOVAL .
  4. On the driver's side, remove the hood latch release handle.
  5. Detach the retaining cover (1) from the cowl sheet metal.
  6. Detach the wiring connector (2) from the cover (1) and disconnect the wiring harness connectors.
    GC0153101Courtesy of CHRYSLER GROUP, LLC
  7. Open the door.
  8. Remove the harness boot (1) at the body side.
  9. Pull the wiring harness (2) from the bodyside opening (3).
    GC0153099Courtesy of CHRYSLER GROUP, LLC
  10. Remove the fastener (2) securing the door's check strap to the body side.
  11. Remove the fasteners (5) securing the door hinges (1, 3) to the body side (4, 5).
  12. With the help of an assistant, lift the door up and out to remove.
scientia non olet · About LEMON Manuals