Module, Anti-Lock Brake System (Abs): Installation

WARNING: This page is about a different variant/trim than selected.

Due to packaging and limited space it is necessary to install the Antilock Brake Module (ABM) on the Hydraulic Control Unit (HCU), then install the Integrated Control Unit (ICU) on the vehicle as an assembly.

Install the Antilock Brake System Module (ABS) on the Hydraulic Control unit (HCU) lining up the solenoids with the valves.

Courtesy of CHRYSLER GROUP, LLC
Install the four bolts (2) mounting the ABS (1) to the HCU (3). Tighten the ABS mounting bolts to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
Install the Integrated Control Unit (ICU) in the vehicle. Refer to INTEGRATED CONTROL UNIT (ICU), INSTALLATION .

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.