Insulator, Engine Mount, Right: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Set the mount (2) into position.
2. Tighten the right mount to frame bolts (3) finger tight.
3. Install the right mount to timing cover bolts (1). Finger tighten the bolts.
4. Tighten the right mount to frame rail bolts (3) to 60 N.m (44 ft. lbs.).
5. Tighten the right mount to timing cover bolts (1) to 60 N.m (44 ft. lbs.).
6. Remove the floor jack supporting the engine.
7. Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
8. Install the belly pan. Refer to BELLY PAN, INSTALLATION .