Diagnostic Test
- CHECK FOR ACTIVE DIAGNOSTIC TROUBLE CODE (DTC) NOTE:
Before proceeding with this diagnostic procedure, remove any ice, snow, mud, dirt, or other obstructions from the front/rear fascia.
- Turn the ignition on.
- Using the scan tool, read Park Assist Module DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- PARK ASSIST SENSOR
- Verify that none of the possible causes mentioned above are present. Repair as necessary.
If possible none of the causes mentioned above are present, view repair.
Repair
- Replace the Park Assist Sensor in accordance with the service information. Refer to REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Verify that none of the possible causes mentioned above are present. Repair as necessary.