Sensor, Park Assist: Removal
NOTE:
The park assist sensors (1) and the resilient sensor spacers (2) (also known as decoupling rings or O-rings) are each available for separate service replacement. The sensor brackets (3) are bonded to and integral to the back side of the rear bumper fascia (4).
- Disconnect and isolate the negative cable from the battery.
- From the back of the fascia (4), disconnect the wire harness connector from the park assist sensor (1) connector receptacle.
- Carefully pry the sensor bracket (3) latch features away from the latch tabs of the sensor far enough to disengage the sensor from the bracket.
- Disengage the resilient O-ring spacer (2) from around the circumference of the sensor membrane protrusion.