LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 70 (Ignition System (Service Information) - 1.4L 16-Valve Turbo - 500) >> Sensor, Camshaft Position >> Removal

Sensor, Camshaft Position: Removal

WARNING: This page is about a different variant/trim than selected.
GC0153787Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body (1)

    Refer to BODY, AIR CLEANER, REMOVAL .

    GC0155887Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the PCV hose (1) from the intake manifold.
  4. Disconnect the vent hose (3) from the cylinder head cover.
  5. Remove three bolts (2) and remove the oil separator housing (4) from the cylinder head cover.
    GC0152657Courtesy of CHRYSLER GROUP, LLC
  6. Unlock and disconnect the Camshaft Position (CMP) sensor wire harness connector (1).
    GC0152503Courtesy of CHRYSLER GROUP, LLC
  7. Remove the mounting bolt (2) and Camshaft Position (CMP) sensor (1).
    GC0152504Courtesy of CHRYSLER GROUP, LLC
  8. The Camshaft Position (CMP) sensor O-ring (1) can be reused if not damaged.
scientia non olet · About LEMON Manuals