Coil, Ignition: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the negative battery cable.
- Remove the air cleaner body (1)
Refer to BODY, AIR CLEANER, REMOVAL .
- Disconnect the vent hose (3) from the cylinder head cover.
Number 1 cylinder ignition coil shown, all others similar.
- Unlock and disconnect the electrical connector (1) from the ignition coil.
- Remove the ignition coil mounting bolt (2).
- Pull the ignition coil (3) from cylinder head cover opening with a slight twisting action.