LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 45 (Aw60T (Hd) Automatic Transmission (Service Information) - 500) >> Cable, Shift >> Removal

Cable, Shift: Removal

WARNING: This page is about a different variant/trim than selected.
GC0153005Courtesy of CHRYSLER GROUP, LLC
  1. Remove the battery tray. Refer to REMOVAL .
  2. Disconnect the gear shift cable (1) from the manual control lever.
    NOTE:

    Inspect the retention clip for cracks, wear or damage, replace as necessary.

  3. Disconnect the gear shift cable from the bracket (2) by holding the tabs (3) and squeezing together, walk the gear shift cable out of the bracket.
  4. Remove the gear shifter assembly. Refer to SHIFTER, TRANSMISSION, REMOVAL .
    GC0152805Courtesy of CHRYSLER GROUP, LLC
  5. Unseat the gear shift cable grommet (1) then push through the floor.
  6. Raise and support the vehicle. Refer to HOISTING .
    GC0153084Courtesy of CHRYSLER GROUP, LLC
  7. Remove the gear shift cable (2) from the retaining clip (1).
  8. Reposition the heat shield to allow for the removal of the gear shift cable.
  9. Remove the gear shift cable from the vehicle.
scientia non olet · About LEMON Manuals