Cover(S), Engine Timing: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the side timing belt cover (1) with bolt (2) tightened to 25 N.m (18 ft. lbs.).
- Install the lower timing belt cover (1) with bolt (2) tightened to 9 N.m (80 in. lbs.).
- Install the vibration damper (1). Refer to DAMPER, VIBRATION, INSTALLATION .
- Install the accessory drive belt (4). Refer to BELT, SERPENTINE, INSTALLATION
.
- Install the frame splash shield (3) with three screws (1).
- Install two screws (2) to the front wheelhouse splash shield.
- Install the right vertical brace (5) with two bolts (4) tightened to 45 N.m (33 ft. lbs.).
- Install the right front wheel and tire assembly. Refer to INSTALLATION
.
- Lower the vehicle.
- Install the upper timing belt cover (1) with two bolts (2 and 3) tightened to 9 N.m (80 in. lbs.).
- Engage the following retainers to the upper timing belt cover (1):
- Wastegate solenoid pressure inlet hose (2).
- After run coolant pump return hose (3).
- Evaporative emissions purge hose (4).
- Position the turbocharger wastegate solenoid (4). Install the bolt (5) and tighten to 9 N.m (80 in. lbs.).
- Install the air cleaner body (1)
Refer to BODY, AIR CLEANER, INSTALLATION .
- Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).