LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Engine Block >> Damper, Vibration >> Installation

Damper, Vibration: Installation

WARNING: This page is about a different variant/trim than selected.
GC0152462Courtesy of CHRYSLER GROUP, LLC
  1. Align the locator pin on the crankshaft sprocket with the hole in the vibration damper (1). Install the vibration damper (1) with three bolts (2) tightened to 25 N.m (19 ft. lbs.).
    GC0152365Courtesy of CHRYSLER GROUP, LLC
  2. Install the accessory drive belt (4). Refer to BELT, SERPENTINE, INSTALLATION .
    GC0153366Courtesy of CHRYSLER GROUP, LLC
  3. Install the frame splash shield (3) with three screws (1).
  4. Install two screws (2) to the front wheelhouse splash shield.
  5. Install the right vertical brace (5) with two bolts (4) tightened to 45 N.m (33 ft. lbs.).
    GC0152555Courtesy of CHRYSLER GROUP, LLC
  6. Install the right front wheel and tire assembly. Refer to INSTALLATION .
NOTE:

The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components. Refer to 1.4L - INTERMITTENT CONDITION, POWERTRAIN VERIFICATION TEST & PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE - 500 .

scientia non olet · About LEMON Manuals