LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2017 >> 500 Lounge, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (1.4L 16-Valve Turbo Engine (Service Information) - 500) >> Engine Mounting >> Insulator, Engine Mount, Right >> Removal

Insulator, Engine Mount, Right: Removal

WARNING: This page is about a different variant/trim than selected.
GC0153787Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the air cleaner body (1). Refer to BODY, AIR CLEANER, REMOVAL .
    GC0082359Courtesy of CHRYSLER GROUP, LLC
  3. Raise and support the vehicle. Refer to HOISTING .
  4. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  5. Drain the cooling system. Refer to STANDARD PROCEDURE .
    GC0152449Courtesy of CHRYSLER GROUP, LLC
  6. Remove four bolts (1) and the tunnel support brace (2).
    GC0156417Courtesy of CHRYSLER GROUP, LLC
  7. Lower the vehicle.
  8. Disconnect the coolant hose (3) from the pressurized coolant bottle (1).
  9. Remove the two bolts (5) and reposition the pressurized coolant bottle (1).
    GC0152565Courtesy of CHRYSLER GROUP, LLC
  10. Support the engine with a floor jack positioned under the oil pan.
  11. Remove six bolts (1 and 3) and the right engine mount isolator (4).
scientia non olet · About LEMON Manuals