Bracket, Engine Mount, Right: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the battery negative cable.
- Raise and support the vehicle. Refer to HOISTING .
- Remove the belly pan. Refer to BELLY PAN, REMOVAL .
- Lower the vehicle to allow a jack stand to be positioned under the engine for support. Using a block of wood, support the engine.
- Remove the air cleaner body (1)
Refer to BODY, AIR CLEANER, REMOVAL .
- Remove the two bolts (5) and reposition the pressurized coolant bottle (1).
- Remove six bolts (1 and 3) and the right engine mount isolator (4).
- Remove the bolt (5) and reposition the turbocharger wastegate solenoid (4).
- Disengage the following retainers from the upper timing belt cover (1):
- Evaporative emissions purge hose (4).
- After run coolant pump return hose (3).
- Wastegate solenoid pressure inlet hose (2).
- Remove the bolts (2 and 3) and the upper timing belt cover (1).
- Remove the six bolts (2) and the RH engine mount bracket (1).