When Monitored

WARNING: This page is about a different variant/trim than selected.

Enable Conditions for Odd Clutch Check

This diagnostic is performed if the ignition key is on, the engine is in run mode, the driveline speed is lower than a threshold, the accelerator pedal is not pressed, the system is not in creeping mode, the previous conditions have been satisfied for a calibrated amount of time, the kiss point learning procedure is requested, the actual gear is not an odd gear (1st, 3rd, 5th) or the Reverse gear, an odd gear (1st, 3rd, 5th) or the Reverse gear is not pre-selected, the requested gear is not 1st, the actual gear is the neutral, the even shaft speed is lower than a threshold, the odd clutch temperature is lower than a threshold and the odd clutch has been closed at least once during the drive cycle.

Enable Conditions for Even Clutch Check

This diagnostic is performed if the ignition key is on, the engine is in run mode, the driveline speed is lower than a threshold, the accelerator pedal is not pressed, the system is not in creeping mode, the previous conditions have been satisfied for a calibrated amount of time, the kiss point learning procedure is requested, the actual gear is not an even gear (2nd, 4th, 6th), an even gear (2nd, 4th, 6th) is not pre-selected, the requested gear is the 1st and the even clutch is open OR the actual gear is the neutral, the odd shaft speed is lower than a threshold, the even clutch temperature is lower than a threshold and the kiss point position learning procedure for the odd clutch is not running OR the kiss point position learning procedure for the odd clutch has correctly completed.