Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CLUTCH FRICTION POINT LEARNED

Using the scan tool, perform the Clutch Contact Point Calibration.
Did the Clutch Contact Point Calibration complete successfully?

Yes
- Repair complete.
- Perform C635 DDCT VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Check transmission hydraulic operation, transmission mechanical operation, and valve body in accordance with the Service information. Repair as necessary.
- If no hydraulic or mechanical problems are found, and using the schematics as a guide, check the Transmission Control Module (TCM) terminals and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. Check for any Service Information Tune-ups or Service Bulletins for possible causes that may apply. If no problems are found, replace and program the Transmission Control Module (TCM) in accordance with the Service Information.
- Perform the C635 DDCT VERIFICATION TEST. Refer to STANDARD PROCEDURE .