When Monitored

WARNING: This page is about a different variant/trim than selected.

Enable Conditions for Check 1

This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the system is in disengagement mode and the target gear is the 3rd gear.

Enable Conditions for Check 2

This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the system is in disengagement mode and the target gear is the 2nd gear.

Enable Conditions for Check 3

This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the system is in disengagement mode and the target gear is the Reverse gear.

Enable Conditions for Check 4

This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the system is in disengagement mode and the target gear is the 4th gear.

Enable Conditions for Check 5

This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the system is in disengagement mode and the target gear is the 1st gear.

Enable Conditions for Check 6

This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the system is in disengagement mode and the target gear is the 6th gear.

Enable Conditions for Check 7

This diagnostic is performed if ignition key is on OR the control unit is in power-on state, the engine is not in cranking mode, the system is in disengagement mode and the target gear is the 5th gear.