When Monitored
WARNING: This page is about a different variant/trim than selected.
Ignition key is ON or the TCM control unit is in power-on state. The engine is not in cranking mode.
Power supply must be between 7 volts and 24 volts and Main Micro Processor (MMP) supply has not failed.
The Even Clutch Pressure Sensor Diagnostic has not failed.
The Even Clutch Electrovalve Diagnostic has not failed.
The pump has been activated at least once during the drive cycle.
The Hydraulic Pressure Sensor Electrical Diagnostic has failed or the hydraulic pressure is lower than a threshold.