Test 46A - Symptoms & Possible Causes (DTC 60, 61 & 62)

NOTE: Perform TEST 2A before proceeding with this test. For connector terminal identification, see CONNECTOR IDENTIFICATION . For wiring diagrams, see WIRING DIAGRAMS . Perform VERIFICATION TEST VER-1A after each repair.

Turn ignition on. Ensure shift lever is in "P" position. Using scan tool, monitor Clutch Volume Index (CVI) value. Record each clutch volume. Clutch volume should be within following ranges; LR: 35-85, 2-4: 20-77, OD: 75-150, UD: 24-70. The volumes of transaxle fluid needed to apply friction elements are continuously monitored and learned for adaptive controls. Volume of fluid needed to apply element increases as friction material wears. Codes 60, 61 and/or 62 are set when volume is less than CVI value. If clutch volumes are not within range, transaxle may have internal failure. See AUTO TRANS OVERHAUL - CHRYSLER 41TE/AE overhaul article. Other transmission problems may also cause similar symptoms but not set diagnostic trouble codes. Verify customer's complaint and determine possible malfunctioning component.