Coolant - Crossover: Installation

Courtesy of CHRYSLER GROUP, LLC

Clean the gasket sealing surfaces.
Install a NEW gasket onto the coolant crossover.
NOTE:
The shorter M6 mounting bolts (2), bolt directly to the engine timing cover.
Install the coolant crossover and tighten the M6 bolts in a crisscross pattern to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
Connect the heater supply hose to the coolant crossover (1).
Install the engine mount bracket and the engine mount. Refer to INSULATOR, ENGINE MOUNT, REAR, INSTALLATION .
Install the thermostat housing. Refer to THERMOSTAT, INSTALLATION .
Fill the cooling system. Refer to COOLANT SYSTEM AIR EVACUATION .
Start and warm the engine and check for leaks.