Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read TCM DTCs and record on the repair order.
2. Record the Event Data and Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read TCM DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK (T3) TRS SIGNAL CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Disconnect the TCM harness connector.
3. Disconnect the Transmission assembly harness connector.
4. Measure the resistance of the (T3) TRS Signal circuit between the TCM harness connector and the transmission assembly harness connector.
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Go To 3
  No
  - Repair the (T3) TRS Signal circuit for an open.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
CHECK (T3) TRS SIGNAL CIRCUIT FOR A SHORT ANOTHER CIRCUIT
1. Check for continuity between the (T3) TRS Signal circuit and all other circuits at the TCM harness connector.
  Is there continuity between the (T3) TRS Signal circuit and any other circuit?
  
  Yes
  - Repair the (T3) TRS Signal circuit for a short to another circuit.
  - Perform the Transmission Verification Test. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
  No
  
  NOTE:
  If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu.
  - Using the schematics as a guide, check the Transmission Control Module (TCM) terminals and connectors for corrosion, damage or pushed out terminals. Pay particular attention to the power and ground circuits. If no problems are found, replace the TCM and perform programming and PROXI Configuration Alignment procedures. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL .
  - Perform the Transmission Verification Test. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
  - If vehicle does not pass the Transmission Verification Test, replace the TRS in accordance with the Service Information. Refer to SENSOR, FLUID PRESSURE, REMOVAL .
  - Perform the Transmission Verification Test. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .