LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis >> Steering >> Steering Linkage >> Steering System >> Gear >> Removal >> Steering Gear

Steering Gear

NOTE:

Do not disconnect the torque sensor (grey) harness connector and make sure it is connected properly.

  1. Remove the front crossmember. Refer to CROSSMEMBER, FRONT SUSPENSION, REMOVAL .
    GC0203926Courtesy of CHRYSLER GROUP, LLC
  2. Remove the steering gear heat shield bolts (1) and remove the shield (2).
    GC0204099Courtesy of CHRYSLER GROUP, LLC
  3. Remove the steering gear bolts (1) and remove the steering gear from the crossmember.
  4. Remove the outer tie rods. Refer to TIE ROD, STEERING, REMOVAL .
scientia non olet · About LEMON Manuals