Reservoir, Windshield Washer: Installation: Reservoir

Courtesy of CHRYSLER GROUP, LLC

1. Position the washer reservoir (2) onto the top of the right front fender wheel house. Be certain that the locating pins on the bottom of the reservoir are fully seated into the bushings in the top of the right front wheel house panel.
2. Install and tighten the screw (3) that secures the mounting bracket (1) to the mounting tab of the washer reservoir. Tighten the screw securely.
3. Install and tighten the screw (4) that secures the washer reservoir mounting bracket to the right front body structure. Tighten the screw securely.
4. Install the filler neck onto the washer reservoir. Refer to RESERVOIR, WINDSHIELD WASHER, INSTALLATION .
5. Install the washer pump/motor unit onto the washer reservoir. Refer to PUMP, WINDSHIELD WASHER, INSTALLATION .
6. Install the right front lamp unit into the vehicle. Refer to UNIT, FRONT LAMP, INSTALLATION .
7. Connect the negative battery cable.
8. Fill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.