Pump, Windshield Washer: Installation

Courtesy of CHRYSLER GROUP, LLC

1. Lubricate a new rubber grommet seal with clean washer fluid and install it into the washer pump mounting hole in the washer reservoir. Always use a new rubber grommet seal on the reservoir.
2. Position the inlet nipple on the base of the pump housing of the washer pump/motor unit to the rubber grommet seal in the reservoir.
3. Using hand pressure, press firmly and evenly downward on the top of the washer pump/motor unit until the inlet nipple is fully seated in the rubber grommet seal in the pump mounting hole of the reservoir.
4. Connect the washer hose (2) to the barbed outlet nipple of the washer pump (3).
5. Connect the engine compartment wire harness connector (1) for the washer pump/motor unit to the connector receptacle on the top of the motor.
6. Connect the negative cable to the battery.
7. If removed, install the filter screen into the filler neck.
8. Fill the washer reservoir with the washer fluid drained from the reservoir during the removal procedure.