Linkage, Wiper Arm: Installation

Courtesy of CHRYSLER GROUP, LLC

NOTE:

The wiper linkage module includes the wiper motor.

Position the wiper linkage module onto the dash panel as a unit.
Install and tighten the three screws (3) that secure the module bracket to the dash panel. Tighten the screws to the proper specifications. Refer to TORQUE SPECIFICATIONS .
Engage the wire harness retainer with the linkage module bracket.
Connect the wire harness connector to the connector receptacle for the wiper motor (2).
Install the cowl plenum cover/grille panels over the wiper linkage module. Refer to COVER, COWL PANEL, INSTALLATION .
Connect the negative battery cable.
NOTE:
Be certain to turn the ignition switch to the On position, then turn the wiper switch On and Off again to cycle the wiper motor and linkage to their natural park position before installing the wiper arms onto the wiper pivots.
Install both wiper arms onto the wiper pivots. Refer to ARM, WIPER, INSTALLATION .