Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Start the engine and test drive the vehicle.
  WARNING:
  When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing. Failure to follow these instructions may result in possible serious or fatal injury.
2. With the scan tool, read DTCs and record on the repair order.
  Is the DTC active or pending?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
ENGINE OIL/ENGINE MECHANICAL
1. Turn the ignition off.
2. The following items should be checked before continuing with this procedure. Failure to do so may lead to misdiagnosis.
  - LOW ENGINE OIL LEVEL
  - AERATED ENGINE OIL
  - INCORRECT ENGINE OIL FILTER (DOES NOT MEET OEM SPECIFICATIONS)
  - DETERIORATED OR DIRTY OIL
  - CONTAMINATED ENGINE OIL
  - INCORRECT ENGINE OIL VISCOSITY
  Were any of the above conditions present?
  
  Yes
  - Repair the engine oiling or mechanical condition (i.e. improper oil drain back, oil sludge, damaged oil pump, pick-up tube or seal, etc.).
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 3
CHECK THE ENGINE OIL PRESSURE
1. Remove the Oil Pressure Sensor and connect an oil pressure gauge to the engine. Refer to SENSOR, OIL PRESSURE, REMOVAL .
2. Start the engine and monitor the oil pressure gauge.
  WARNING:
  When the engine is operating, do not stand in direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing. Failure to follow these instructions may result in possible serious or fatal injury.
3. Raise the engine speed while monitoring the oil pressure gauge.
  Does the engine produce enough oil pressure to enable VVT actuation?
  
  Yes
  - Go To 4
  No
  - Repair the engine for loss of oil pressure.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
ENGINE OIL PRESSURE SENSOR
1. Turn the ignition off.
2. Replace the Engine Oil Pressure Sensor in accordance with the Service Information.
3. With the scan tool, erase DTCs.
4. Start the engine and test drive the vehicle.
5. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 5
  No
  - Repair is complete.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
POWERTRAIN CONTROL MODULE (PCM)
1. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors between the Engine Oil Pressure Sensor and the Powertrain Control Module (PCM).
2. Look for any chafed, pierced, pinched, or partially broken wires.
3. Look for broken, bent, pushed out or corroded terminals. Verify that there is good pin to terminal contact in the Sensor and Powertrain Control Module connectors.
4. Perform any Service Bulletins that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Replace and program the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .