LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (5.7L Engine (Service Information) (1 Of 2)) >> Cylinder Head >> Removal >> Removal - Right Cylinder Head

Removal - Right Cylinder Head

WARNING: This page is about a different variant/trim than selected.
GC0209731Courtesy of CHRYSLER GROUP, LLC
  1. Remove the oil fill cap (1).
  2. Remove the engine cover (2).
  3. Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
  4. Disconnect and isolate the negative battery cable.
  5. Remove the cowl cover panel. Refer to COVER, COWL PANEL, REMOVAL .
  6. Drain the cooling system. Refer to FUEL SYSTEM PRESSURE RELEASE .
  7. Disconnect the exhaust system from the exhaust manifold. Refer to MANIFOLD, EXHAUST, REMOVAL, 5.7L .
  8. Remove the air cleaner and resonator assembly. Refer to BODY, AIR CLEANER, REMOVAL  .
  9. Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL  .
  10. Remove the engine oil indicator tube retaining nut at the exhaust manifold and remove the oil indicator tube.
  11. Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .
  12. Remove the exhaust manifold bolts. Refer to MANIFOLD, EXHAUST, REMOVAL, 5.7L .
  13. Remove the rocker arms and push rods. Refer to ROCKER ARM, VALVE, REMOVAL  .
    Fig 1: LH Cylinder Head Loosening Sequence
    GC0209737Courtesy of CHRYSLER GROUP, LLC
  14. Using the sequence shown, remove the cylinder head bolts.
  15. Remove the cylinder head and discard the cylinder head gasket.
scientia non olet · About LEMON Manuals