LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (5.7L Engine (Service Information) (1 Of 2)) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal

Cover(S), Cylinder Head: Removal

WARNING: This page is about a different variant/trim than selected.
GC0209731Courtesy of CHRYSLER GROUP, LLC
  1. Remove the oil fill cap (1).
  2. Remove the engine cover (2).
    GC0208685Courtesy of CHRYSLER GROUP, LLC
  3. Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
  4. Disconnect and isolate the negative battery cable (2).
    GC0209730Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the EVAP vacuum line (1) at the throttle body.
  6. Disconnect the fuel supply line (2) at the fuel rail.
  7. Disconnect the make up air hose (3) at the intake manifold.
    GC0209699Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the ignition coil electrical connectors (1).
  9. Remove the ignition coil retaining bolts (3).
    GC0209979Courtesy of CHRYSLER GROUP, LLC
  10. Remove the ignition coils (1).
  11. Remove the wiring harness retainers at the cylinder head cover and position wiring harness aside.
    Fig 1: Cylinder Head Cover Loosening Sequence
    GC0209739Courtesy of CHRYSLER GROUP, LLC
  12. Using the sequence shown, remove the cylinder head cover retaining bolts.
    GC0209729Courtesy of CHRYSLER GROUP, LLC
  13. Remove the cylinder head cover (2).
    NOTE:

    The cylinder head cover gasket (1) may be used again, provided no cuts, tears, or deformation have occurred.

  14. Inspect the cylinder head cover gasket (1), replace if necessary.
scientia non olet · About LEMON Manuals