LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2023 >> Durango GT, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (5.7L Engine (Service Information) (1 Of 2)) >> Cylinder Head >> Removal >> Removal - Left Cylinder Head

Removal - Left Cylinder Head

WARNING: This page is about a different variant/trim than selected.
GC0209731Courtesy of CHRYSLER GROUP, LLC
  1. Remove the oil fill cap (1).
  2. Remove the engine cover (2).
  3. Perform the fuel pressure release procedure. Refer to FUEL SYSTEM PRESSURE RELEASE .
  4. Disconnect and isolate the negative battery cable.
  5. Remove the cowl cover panel. Refer to COVER, COWL PANEL, REMOVAL .
  6. Drain the cooling system. Refer to FUEL SYSTEM PRESSURE RELEASE .
  7. Remove the air cleaner and resonator assembly. Refer to BODY, AIR CLEANER, REMOVAL  .
  8. Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL  .
  9. Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .
  10. Remove the rocker arms and push rods. Refer to ROCKER ARM, VALVE, REMOVAL  .
    Fig 1: RH Cylinder Head Loosening Sequence
    GC0209737Courtesy of CHRYSLER GROUP, LLC

    Right side shown, left side similar. 

  11. Using the sequence shown, remove the cylinder head bolts.
  12. Remove the cylinder head and discard the cylinder head gasket.
scientia non olet · About LEMON Manuals