Clutch, A: Disassembly

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

1 - A CLUTCH PISTON

8 - SUN GEAR

2 - LIP SEAL

9 - WAVE SPRING

3 - LIP SEAL

10 - SEPARATOR PLATE

4 - RETURN SPRING

11 - FRICTION PLATES

5 - RING

12 - END PLATE

6 - BEARING

13 - SNAP RING

7 - WASHER

14 - SELECTABLE SHIM

Remove the oil pump from the transmission case. Refer to PUMP, TRANSMISSION OIL, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Apply air pressure slowly, oil may spray when the clutch B piston releases from the assembly.
With one hand above the clutch B piston (1), carefully apply air pressure into the hole directly above the clutch B piston alignment tab (3) to remove clutch B piston (2) from the assembly.

Courtesy of CHRYSLER GROUP, LLC
Remove the outer ring (1) (inside clutch B piston).
Remove the snap ring (2).
Remove the clutches and spacers (4).
Remove the hub (3).

Courtesy of CHRYSLER GROUP, LLC
Position the oil pump housing assembly (4) in a suitable press.
Using (special tool #8285, Compressor, Spring) (1), press on the fingers of the belleville spring to remove tension on the split retaining ring (2), and remove the two halves of the retaining ring (2).

Courtesy of CHRYSLER GROUP, LLC
Remove the belleville spring (1) and clutch A piston.