Diagnostic Test

CHECK FOR AN ACTIVE DTC
NOTE:
Verify the connection of the ANC Microphone 2 harness connector.
1. Turn the ignition on.
2. With the scan tool, read DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (X462) ANC MICROPHONE 2 (+) CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the Amplifier C2 harness connector.
3. Disconnect the ANC Microphone 2 harness connector.
4. Turn the ignition on.
5. Measure the voltage between ground and the (X462) ANC Microphone 2 (+) circuit at the Amplifier C2 harness connector.
  Is there any voltage present?
  
  Yes
  - Repair the (X462) ANC Microphone 2 (+) circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE (X463) ANC MICROPHONE 2 (-) CIRCUIT FOR A SHORT TO VOLTAGE
1. Measure the voltage between ground and the (X463) ANC Microphone 2 (-) circuit at the Amplifier C2 harness connector.
  Is there any voltage present?
  
  Yes
  - Repair the (X463) ANC Microphone 2 (-) circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Amplifier in accordance with the Service Information. Refer to AMPLIFIER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .