Valves, Intake And Exhaust: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the cylinder head(s). Refer to CYLINDER HEAD, REMOVAL NOTE:
If the springs are to be reused, identify their positions so that they can be reassembled into their original locations.
- Remove the valve spring(s). Refer to SPRING(S), VALVE, REMOVAL .CAUTION:
Before removing the valves, remove any burrs from the valve stem retainer lock grooves (2) and stem tip (1) to prevent damage to the valve guides.
- Remove the valve(s) (3). Identify each valve to ensure installation in the original location.
- If required, remove the valve guide seal and spring seat. Refer to REMOVAL