LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (3.6L Engine (Service Information)) >> Cylinder Head >> Solenoid, Variable Valve Lift >> Removal >> Bank 2 Solenoid 1

Bank 2 Solenoid 1

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner body. Refer to REMOVAL 
  2. Disconnect and isolate the negative battery cable.
    GC0173671Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connector (2) from the Variable Valve Lift (VVL) solenoid.
  4. Remove the retaining bolt (1) from the VVL solenoid.
  5. Remove the VVL solenoid from the cylinder head cover.
  6. The O-ring seal can be reused if not damaged.
scientia non olet · About LEMON Manuals