LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (3.6L Engine (Service Information)) >> Cylinder Head >> Solenoid, Variable Valve Lift >> Installation >> Bank 2 Solenoid 1

Bank 2 Solenoid 1

WARNING: This page is about a different variant/trim than selected.
  1. Inspect the Variable Valve Lift (VVL) solenoid O-ring seal and replace if necessary.
    GC0173671Courtesy of CHRYSLER GROUP, LLC
  2. Insert the VVL solenoid into the cylinder head cover.
  3. Install the retaining bolt (1) and tighten to the proper specifications. Refer to TORQUE SPECIFICATIONS  .
  4. Connect the wire harness connector (2) to the VVL solenoid.
  5. Connect the negative battery cable.
  6. Install the air cleaner body. Refer to INSTALLATION 
scientia non olet · About LEMON Manuals